12-pin Microneedle Cartridge

is specially designed to reduce the appearance of acne scarring.

The 12-pin Microneedle Cartridge creates microscopic punctures in the surface of the skin to stimulate collagen production.

Buy Now

Upgraded features to suit the new Dr. Pen A11 Microneedling Pen

  • Newly adopted wavy contact edge to help with better skincare product absorption
  • Newly built three snap connectors to help with the performance and protection of the device machine
  • Easily paired with Dr. Pen A11 Microneedling Pen
  • High-quality stainless steel for the gauge

What’s Included

  • 10x pack of 12-pin Microneedle Cartridges for Dr. Pen A11 Microneedling Pen

DO NOT USE 

  • One cartridge more than once for safety and hygiene reasons
  • On open wounds
  • On broken skin
  • On active acne 
  • Or continue to use if irritation occurs
    Important: Microneedling cartridges must be sterilised before each use to ensure the treatment is safe and hygienic. It is essential to follow these steps carefully to ensure that the microneedling cartridges are properly sterilised. Here are the steps to sterilise microneedling

Before You Start

  1. First, ensure that you have all the necessary equipment for sterilisation: gloves, an isopropyl alcohol solution (70% or above), and a clean container to hold the solution.
  2. Put on your gloves to avoid contaminating the cartridges during the sterilisation process.
  3. Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.
  4. Pour enough alcohol solution into the container, dip the cartridge needle into a sterilisation container, and soak for a couple of minutes.
  5. If you have alcohol solution in a spray model, you can spray it towards the cartridge’s needle head.
  6. Once the sterilisation is complete, allow the cartridge to air dry before using it.
  7. Finally, your cartridge is ready for use.

How to Use

  1. Remove the sterile cover on the top of the cartridge
  2. After that, connect the cartridge to the Dr. Pen A11 Microneedling Pen
  3. Double-cleanse the face, put Hyaluronic Acid serum in the desired small areas for treatment
  4. Turn the pen on, and set the gauge’s depth and pen’s speed according to your preferred specific treatment
  5. Slowly start the treatment in small areas
  6. The recommended pattern is cross-hatch. Use only light pressure to avoid dragging or pulling the skin.
  7. Safely dispose of your microneedling cartridge after one treatment

Usage

Microneedling treatment for acne scarring can only be performed once every 3-4 weeks.

This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.